6. Before use
6.1 Battery use and care
NOTE
Battery performance drops at low temperatures.
Never use the battery until the cells become fully
discharged. Change to the second battery as soon
as a drop in performance is noticed. Recharge the
battery immediately so that it is ready for reuse.
Store the battery in a cool, dry place. Never store
the battery where it is exposed to direct sunlight or
sources of heat, e.g. on heaters / radiators or behind a
motor vehicle windscreen. Batteries that have reached
the end of their life must be disposed of safely and
correctly to avoid environmental pollution.
6.2 Charging the battery
DANGER
Use only the Hilti batteries and Hilti chargers listed
under “Accessories”.
6.2.1 Charging a new battery for the first time
A new battery must be charged correctly for the
first time before use. This will ensure that the cells
form correctly. Incorrect initial charging may have a
permanent, negative effect on battery capacity. Please
refer to the applicable battery charger’s operating
instructions for information about initial charging.
6.2.2 Charging a previously used battery
Ensure that the outer surfaces of the battery are
clean and dry before inserting it in the corresponding
charger.
Read the operating instructions for the charger for
further information about the charging procedure.
Li-ion batteries are ready for use at any time, even
when only partly charged. Charging progress is in-
dicated by the LED display (see charger operating
instructions).
6.3 Fitting the battery 2
CAUTION
Before fitting the battery, check that the power tool
is switched off and that the safety lock is engaged
(forward/reverse switch in the middle position). Use
only the Hilti batteries approved for use with this
power tool.
CAUTION
Check that the terminals on the battery and in the
power tool are free from foreign objects before
inserting the battery in the power tool.
1. Push the battery into the power tool from the
rear as far as it will go and until it is heard to
engage with a double click.
2. CAUTION A falling battery may present a risk
of injury to yourself or others.
Check that the battery is seated securely in the
power tool.
6.4 Removing the battery 2
1. Press both battery release buttons.
2. Pull the battery out of the power tool toward the
rear.
6.5 Transport and storage of battery packs
Pull the battery pack out of the locked position (work-
ing position) and move it into the first latching position
(transport position).
If you disconnect a battery pack from the power tool
for transport or storage, make sure that the contacts
of the battery pack are not short-circuited. Remove
loose metal parts such as screws, nails, clamps,
loose screw bits, wires or metal swarf from the case,
toolbox or transport container, or prevent these parts
from coming into contact with the battery packs.
Observe national and international transport regula-
tions when shipping battery packs (transportation by
road, rail, sea or air).
en
8
(19 Seiten)
(11 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern